Your board-compliant seal will be ready for download after purchase
Board approved
Your Connecticut Professional Engineer seal from pedigitalstamps.com meets every requirement on this page — the required wording, the layout and the diameter set out in RCSA § 20-300-10 (License seals and stamps), with the design and size prescribed by the Board. Fill in your details and download it in seconds.
The 1¼-to-2-inch range often quoted for Connecticut appears in no Connecticut authority. The Board prescribes a single diameter, 1½ inches. CGS § 20-304 is only the enabling authority for seal regulations, and CGS § 20-302 is "Requirements for licensure" — neither describes the seal.
Full Connecticut PE seal requirements, with every citation →
File formats
HIGH-QUALITY RASTER FORMAT
VECTOR FORMAT, INFINITELY SCALABLE
UNIVERSAL DOCUMENT FORMAT
AUTOCAD COMPATIBLE FORMAT
PROFESSIONAL PRINT FORMAT
How it works
Select your state & profession
Add your name & license number
Adjust the text size using the controls
Select your discipline
Add your signature & customize (optional)
Download instantly to your computer
Software compatibility
Who we are
Our digital Connecticut PE stamp generator creates instant state-approved electronic pe stamps. Our platform provides full customization of your digital seal, including an option to add your signature. Professional Engineer (PE) stamps, Architect stamps, and Land Surveyor stamps are available for immediate download after customization. There is no waiting. Every electronic professional seal we generate is 100% compliant with state board requirements, ensuring your digital stamp meets all necessary standards.
State boards
FAQ
Frequently asked questions about Connecticut digital engineer stamps and seals.
Once you are licensed in Connecticut, you can generate your seal here and download it immediately. Fill in the form and position your signature if you want one. The layout follows RCSA § 20-300-10 (License seals and stamps), with the design and size prescribed by the Board, which is the provision the State Board of Examiners for Professional Engineers and Land Surveyors will measure the seal against.
Connecticut’s PE seal rule is RCSA § 20-300-10 (License seals and stamps), with the design and size prescribed by the Board, administered by the State Board of Examiners for Professional Engineers and Land Surveyors. The seal must carry “LICENSED PROFESSIONAL ENGINEER”, and 1½ inches in diameter, as prescribed by the Board. There is no range — the regulation itself states no dimension and leaves size to the Board.
A further 6 requirements, each tied to the subsection that imposes it, are itemised in the Connecticut requirements section on this page.
1½ inches in diameter, as prescribed by the Board. There is no range — the regulation itself states no dimension and leaves size to the Board. This is set by Board seal specification (12 July 2022), under RCSA § 20-300-10(a).
"P.E." is not an authorized substitute. The Board-prescribed design carries the words "LICENSED PROFESSIONAL ENGINEER" in full, and "Licensed" has been mandatory for every license issued since July 1, 1982. (Board seal specification (12 July 2022))
Put the license number on the seal without the "PEN" or "LSX" prefix and without the leading zeros. (Board seal specification (12 July 2022))
An electronic document carrying only a graphical facsimile of the stamp is not a sealed document. Where the facsimile cannot be erased or removed, the document must carry a prominent note reading "This shall not be considered a sealed document." (RCSA § 20-300-10(c)(6))
Sealing one sheet of a bound set is enough in general, but plans filed for building permits and appurtenant structures must be sealed on every sheet. (RCSA § 20-300-10(a))
